2" Lift Block Kit (Tandem Axle Trailer)

For 10% off
Check out our new part numbers
1" lift block kits:  Click here
2" lift block kits:  Click here
3" lift block kits:  Click here

BEFORE ORDERING, CONFIRM YOUR SPRINGS ARE ON TOP OF THE AXLE!

If they are located under the spring please look at purchasing a over/under conversion kit instead which can be found here: Flip Kit.

This kit contains 2" lift blocks to lift a TANDEM-AXLE trailer. 

**Verify springs are 1 3/4" wide and it only works if springs are on top of the axle

Always measure your Ubolts on the threaded part
1/2" or 0.500" measured on threads
9/16" or 0.562" measured on threads

Includes:

(4) 2" Fabricated lift blocks
(8) Ubolt come bent at either 2 3/8" round at 8.5" long or 3" round at 9.5" long.  Ubolts come either 1/2" or 9/16" in diamter (check variants)
(16) Nuts and washers for Ubolts

Torque 1/2" Ubolts to 75-90 FTLBS
Torque 9/16" Ubolts to 90-120 FTLBS

Some Ubolt plates can't handle the higher torque ratings so start at the lower torque settings and work your way to a higher level of torque.

These kits are made from all Canadian steel.
Steel bars are made in Canada
Ubolt rods are made in Canada
Blocks are fabricated and Ubolts are bent all by Simcoe Spring Service in Ontario Canada

Old Part numbers:  TLBK-238, TLBK238, TLBK300, TLBK-300